Roofing Valley Transition

The lower roof unavoidably slows down water drainage and when the valley is clogged a significant amount of water coming down that valley will tend to spread out and back up under the shingles.

Roofing valley transition.

Apply an approximately 3 inch width of asphalt roofing cement along the sides of flashing and embed shingles in mastic clip the top corner of shingles along valleys to keep water flow toward center of valley. In order to shingle this kind of roof valley a roofing professional has to install both roof faces at the same time which is quite slow. Cut the panels from the ground instead of on the roof to avoid damaging the roof with the debris. Valleys are prone to collecting leaves particularly if someone sets up an antenna at the base of the valley.

Fold the top over the roof ridge and cut the bottom along the drip edge metal. How to seal metal roof valley. With a clean valley you can lay down some peel and stick roofing membrane. Take care not to place any fasteners in the exposed center area of the metal flashing.

At the roof transition shown in. Low slope roofs slope less than 3 12 use tape sealant between the valley trim and the panel. Best practices for sealing the metal roof valley vary based on the slope of the roof. Valleys are typically found where gable dormer roofs meet the main roof or when a house has angled wings or additions where two roof sections in different planes meet.